Issues arming esc's together.i read that this is only supported on ppm8 not ppm1 but the page only showed the cc3d and atom. Arming led (hexacopter)wenn der copter gearmt ist? Arming problem « reply #4 on:
Just that it doesn't arm.
I just did a mod on my drone which included soldering the cc3d wires on the receiver. Arming is set to yaw left. It has nothing to do with arming. Hoffe das geht, sonst ist schrauben angesagt grüße logged print.
The computer audibly says “armed” and the motors will. Do i need to swap my tx back. It's what i tried last evening and it doesn't seem to differ from your arming setup. January 19, 2018, 10:32:23 pm » in fact it appears that arming is impossible when flight mode for thrust configured to other.
I have configured the arming feature and the revo will arm (the pfd display indicates armed and autopilot.
If your escs are not beeping after connecting battery and are quite, but later esc bacon signal starts (few minutes after) this means esc. I am trying to get my quad to arm with a switch, instead of how i used to with the. Arming with switchesi've just started using librepilot today after updating from openpilot. When i did that i mixed up a few signal wires but i understand.
Oder geht das nur in dem man die firmware ändert?
