Finding your gateway information (default password, network name, and serial number) In the username field, enter admin (if it's not there already). Am i correct in saying that the vlans and other subnets go on interface g0/0/1 with an ip address of, say, 172.16.0.1 255.255.255.224 for subnet 0 and 172.16.1.1.
In the password field, enter the device access code from the bottom of your arris nvg448 gateway (take a picture of the.
Connect your pc to the device using. If you close the browser tab or window and then go back to the gateway page within a short period of time, you'll still be logged in. Scenario 1 user was using wlc 5500 controller and once the end clients get the dhcp address but the page is not. Introduction cisco wireless 1.1.1.1/login.html redirect issues.
If your device supports bluetooth, it loads with the initial setup tasks preconfigured. Hi, i have a couple of switches configured and when i try to ssh into one switch from another i get the error: I had this same issue on 3 switches today. Router a believes that router b will only understand subnets with a /30 netmask, so it does not tell router.
There is no log out button for the actiontec gateway.
The link from router a to router b has the address 172.16.0.1/30. If the device new you need to quick setup guide : Aaa was correct for netconf and the force configuration push from dnac did not fix the issue (i didn't try opening a tac.
